自锁板端防水连接器

零件编号: admin

面板式防水IP68推拉自锁连接器具有以下特点: 在插合时防水,接触部位防水IP67。经过特殊处理可以达到防水IP68。 插头防水,插头尾部要保证防水,必须要求线缆外直径足够圆,并且组装过程保证密封良好,那么可以达到防水IP68等级。如果线缆不足够圆,可以通过尾部注塑成型,从而保证达到防水IP68等级。插头前端可以通过配一个防尘帽,在不使用插头的时候,用防尘帽保护插头防止进水,插头和防尘帽插合时防水等级也能达到IP68。

立即咨询

The panel type waterproof IP68 push-pull self-locking connector has the following characteristics:

It is waterproof when inserting, and the contact part is waterproof IP67. After special treatment, it can reach waterproof IP68.

The plug is waterproof. To ensure waterproof at the end of the plug, the outer diameter of the cable must be round enough, and the assembly process must be well sealed, so it can reach the waterproof IP68 level. If the cable is not round enough, it can be molded through the tail injection molding to ensure that it reaches the waterproof IP68 level. The front end of the plug can be equipped with a dust cap. When the plug is not used, the dust cap is used to protect the plug from water ingress. When the plug and the dust cap are inserted, the waterproof level can also reach IP68.

The socket is waterproof and the socket prevents water from entering the device. If the socket wants to be waterproof, it can also be equipped with a dust cap to protect the socket from water. When the socket is inserted into the equipment panel, there is an O-ring on the contact surface between the socket and the panel. When the socket is installed into the equipment, the socket shell will squeeze the O-ring to prevent water from entering the equipment, so as to reach the waterproof level of IP68.